MaxTiger Pvc&Vinyl Adhesive ESD – 9071 / AC is a low emission adhesive with a high initial grab for vinyl, polyolefin and rubber floor covering.

Product Typification

• Low emission

• Non-flammable

• Multi-purpose application

• Easy to apply

• Favourable spreading capacity

• Short waiting time

• Long open time

• High stickiness

• Long final adhesion strength

• Odour neutral

• Roller-castor-chair resistant

• Thick liquid

• Consumption : 250 – 300 gr/m²

Application

• PVC floor covering in sheets and tiles

• Cushion vinyl

• PVC backed carpet

• Rubber floor covering with a smooth back in sheets and tiles

• Polyolefin floor covering

Working Process

Storage : Store cool and free from frost.

Open time : 10-120 minutes.

Latency : 10 – 50 minutes.

Drying time : 48 hours.

Shelf life : 12 months, in unopened packaging.

Substratum

• MaxTiger is suitable for any type of subfloor that has a good  tensile and compression strength.

• The subfloor should also be even, clean, permanently dry and

free from grease and dirt, according to the requirements of  procedure.

• When installing on impervious subfloors apply a 2 mm levelling compound layer.

Working conditions

Required surrounding temperature : 18 – 23 °C

Temperature for material and subfloor : Min. 15° – max. 20 ºC.

Relative humidity : 40 – 80%.

•Apply the adhesive with a fine-notched adhesive spreader. Type of spreader depends on the type of floor covering and condition  of the subfloor.

•Immediately after bonding roll the floor covering carefully.

Sheet-ends and longitudinal joints   are to be pressed firmly.

•Rolling and pressing should be repeated after approx.

30-45 minutes.

•Remove fresh adhesive spots immediately with water

•Clean tools with water immediately after use

•MaxTiger can be applied on underfloor heating systems (Turn off the heater 24 hours before application)